SPECIFICATIONS

Sine Wave Controller which support 3-mode (hall sensor mode, non-hall mode, self-learning) and smart match with each motor through self-learning, works with high efficiency, less noise, and lower energy consumption

Universal Input Voltage Range: 36V/48V/52V

Work with or without display, Parameter setting via display

Multi functions: Work with hall sensor mode or non-hall mode, smart match with different motor, 5-speed level for throttle and PAS, Speed limit, Reverse, Cruise, Push Assistant, Anti-thief, Regenerative Braking, Electric Braking and etc

FAQ:1. How to pair my motor for first time use? (1). Lift your motor wheel off ground (very important), (2). Connect Self-learning plug 6-8 seconds, (3). You will see motor wheel rotate slowly, (4). Please check whether rotation direction is correct: (a). If correct direction, then keep 6-8 seconds, then disconnect, (b). If reverse direction, then disconnect and plug again till get correct rotation direction, then keep 6-8 seconds, then disconnect, (5). Motor and Controller Pairing finished!

Parts Including:

1. 15 MOSFET 35A 36V 48V, 52V Universal Voltage 1000W-1500W Intelligent 3-mode Sine Wave Controller

2. 36V, 48V, 52V,72V UKC1 Colorful Display , SW Display, EN06 (Optional)

Advantage:

1. Support dual mode: support hall sensor or Non-hall sensor

2. Self Learning: Even wrong 3-phase combination between motor and controller, doesn’t matter, above self-learning process can correct it!

3. All protection make it long life and safe: over/under voltage, over current, over load, over heating, anti-runaway, locked-motor protection

4. Best heat sinking with Aluminium Case

5. Black anodized Aluminium Controller Case against scratch

Technical Data:

General Specification:

1. Rated Power: 36V 612W/ 48V 816W/ 52V 884W

2. Peak Power: 36V 1260W/ 48V 1680W/ 52V 1820W

3. Brake: Low Voltage Brake

4. Alarm: Low Voltage Alarm

5. Rotor Position Detecting Method: Hall sensor

6. Controller Size: 212x86.5x48.5mm

7. Net Weight: 610g

8. Waterproof Grade: IP65

FAQ:

1. How shall I match my motor for first time use? (Very Important)

1). Lift your motor wheel off ground (very important)

2). Connect Self-learning plug 6-8 seconds

3). You will see motor wheel rotate slowly

4). Please check whether rotation direction is correct

(a). If correct direction, then keep 6-8 seconds, then disconnect

(b). If reverse direction, then disconnect and plug again till get correct rotation direction, then keep 6-8 seconds, then disconnect

5). Motor and Controller Pairing finished!

2. Can I use this controller without display?

Yes, you can use this controller without display, just need to connect jumper connector